TDS Controller 2 Set Point

Hence Work Instruction Digital Electrical Conductivity Controller For Dosing. While TDS Controller 2 Set Point
1. SETTING RELAY OPERATION
Hence SET High limit and Low limit of Electrical Conductivity Value for Buzzer / Relay Operation

a) Press the SET button Upper display shows H-EC the higher limit of Electrical Conductivity to set and lower display shows the value of H-EC already set. Now use / Press UP and DN buttons to set required Higher Limit
b) Press SET button once again Upper display shows L-EC the lower limit of Conductivity to set and lower display shows the value of L-EC already set Now use / Press UP and DN buttons to set required Lower Limit of Conductivity
c) Press SET Button again or ENT button to save the changes else change will not save in memory and remove after power OFF

Technical Specifications : TDS Controller 2 Set Point

1. Range: 0000 to 9999 ucm / mcm
2. Conductivity : 20µ/cms, 200µ/cms, 2mili & 200mil
3. Resolution: 0.01, 0.1
4. Accuracy: ±1%  @ 25°c
5. In Built Display: 4 Digit, Red Led Display
6. Selection Calibration: Single Point
7. Power Requirement: 230v A.c ± 10%, 50hz Single Phase
8. Environment: 5 to 50°c
9. Dimension: 96 x 96 x 80 mm
10. Weight: 1 Kgs (approx)
11. Supply 220 VAc

TDS / Conductivity Meter distributor and supplier ,

Hence (MCS); It is a TDS meter distributor and supplier in India, TDS Meters are used to measure Total Dissolve Salt measured in particles per Millions ie. PPM. We have different type of TDS Meter and Controller for Industrial and Lab Use. Hence please click the link below; to Reed more about. Or Click on Link; to see more products in this category.TDS Controller 2 Set Point

1. Digital TDS meter Online Panel Mounted for Industrial use
2. Digital TDS Meter Table Top for Laboratory Use
3. TDS Controller with 1 Set Point 1 Relay Output
4. TDS Controller with 2 Set Point and 2 Relay Output
5. Sensor / Probe for TDS Meter

Conductivity Meter, Online pH Meter Manufacturers in India

Hence Conductivity Meters are also known as EC meters, While EC or measures in UCM and MCM. While we have different type of Conductivity Meter and Controller. Hence please click the link below; to Reed more about given products. Or Click on Link; to see more products in this category.TDS Controller 2 Set Point

1. Digital Conductivity meter Online used to measure EC value of any solution.
2. Digital Conductivity Meter Table Top for Laboratories

pH Meter
Like MCS Facebook Page for recent offers & Updates!